Lake Stevens advances Lake Line CIPP design to curb infiltration
Lake Stevens Sewer District, Washington · Meeting date: November 12, 2026 · Published: November 17, 2026
Lake Stevens Sewer District commissioners approved a $176,100 amendment with Gray & Osborne to design a cured-in-place pipe rehabilitation programme for ageing sewers around the lake. The work is intended to reduce groundwater and surface-water infiltration into the wastewater collection system without conventional pipe excavation.
Key points
- Commissioners approved Contract Amendment No. 50, worth $176,100, for Gray & Osborne to design the Lake Line CIPP Improvements.
- The Lake Line includes pipes constructed from 1968 onward, including sections beneath private property and within the footprint of Lake Stevens.
- The design scope covers GPS survey, 60%, 90% and final design packages, permit support, bid-and-award services, QA/QC and site visits; construction management is excluded.
- The district said infiltration and inflow consumes treatment capacity and can raise operating and capital costs.
Full report
Lake Stevens Sewer District has moved forward with design work for cured-in-place pipe rehabilitation of its Lake Line, approving a $176,100 professional-services amendment for Gray & Osborne at its 12 November meeting.
The Lake Line CIPP Improvements are intended to reduce infiltration and inflow (I&I) in a group of wastewater pipes running between private residences and the shores of Lake Stevens, principally on the west and north sides of the lake. The district said the lines were first constructed in 1968 and have received only minor modifications since.
Their location creates a particular rehabilitation challenge. Sections of the system are on, within or below private property, while others lie beneath the footprint of the lake. District staff told commissioners that the project would need additional engineering because of its location, permitting requirements and access constraints.
CIPP was selected as the proposed solution because it can form a new wastewater pipe within the existing line without earthworks. Under the method described by the district, a liner is inserted into the existing pipe and hardened with ultraviolet light, then drilled to reconnect side sewers. The district said this should achieve I&I reduction with minimal, if any, loss of conveyance capacity.
The approved Gray & Osborne scope includes GPS surveys of manholes and potential equipment-staging areas, preparation of mapping, and design plans, specifications and cost estimates at 60%, 90% and final stages. It also includes permit investigation and application support, bid and award assistance, document quality reviews, and up to five project meetings and three site-visit trips.
The engineering scope assumes district staff will inspect the Lake Line by closed-circuit television and that the pipes will be suitable for CIPP. If that assumption proves incorrect, revised design or construction methods could require a further contract amendment. Construction management is explicitly excluded from the current scope.
The schedule supplied with the amendment identifies final design as achievable 36 weeks after notice to proceed, followed by advertisement at 38 weeks and construction initiation at 46 weeks.
The district has identified I&I reduction as a way to limit use of valuable wastewater-treatment capacity. It said groundwater and surface water can enter the collection network through leaking pipe joints, manhole covers and manhole structures, increasing treatment needs and potentially driving higher operational and capital costs.
This summary was generated by AI based on the source document and may contain errors.
Source: Regular Board Meeting, Lake Stevens Sewer District